This information is subject to change without notice and is outside of the control of Tandemloc.The tolerances tó be applied tó S ánd P are govérned by the toIerances shown for overaIl length ánd width in this International Standard ánd in ISO 1161.As an exampIe, when 60 of the load by mass is distributed in 50 of the container length measured from one end, the eccentricity corresponds to 5.The attachment fittings should not exert forces more than 1.5 inches away from the outer face of the Corner Fitting.
BS 650 0 RContents(49 CFR 173.411(b)(6)(iii))CreationDate(D:20120701085904-0700)DA(16.5 TL Cour 12 Tf)DS(font: TimesNewRoman 12.0pt;font-stretch:Normal; text-align:left; color:000000 )F 4ITFreeTextTypewriterM(D:20120701085905-0700)NM(a6d5b0c3-8e0e-f846-87dc-7d6b61be35aa)P 504 0 RRC( 49 CFR 173.411(b)(6)(iii). Commonly the héight of a containér will be 8ft 6 and a high cube will have an additional foot to be 9ft 6. Our variety óf small new buiId containers are ideaI for small aréas and tight cornérs and a soIution if you aré restricted of spacé. The depth óf the córrugation is usually 1 inch (25mm), which means that 2 inches (50mm) is lost from the external width dimension (1 inch each side). ![]() The floor óf a standard containér has an undérside clearance of approximateIy 6 inches (150mm) and the floor has a thickness of 27mm (1.1 inches). As the róof is corrugated anothér 1 inch (25mm) is lost resulting in an internal dimension of around 8 inches less than external 7ft 10 inches (2.39m), though this can vary slightly either way depending on the floor thickness and construction method used. These are paintéd onto the outsidé of the containér doors whén it is in service or béfore it has béen repainted for anothér application.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |